Technical Proceedings of the 2010 NSTI Nanotechnology Conference & Expo - Nanotech 2010
Produced by
|
|
Nanotech 2010 Vol. 2
Chapter 5: MEMS Fab: Design, Manufacture, Instrumentation
Machining Using Fast Tool Servo Combined with Ultrasonic Vibrator
|
| Authors: | S.C. Choi, Lu Hong, D.W. Lee |
| Affiliation: | Pusan University, KR |
| Pages: | 296 - 299 |
| Keywords: | fast tool servo, ultrasonic vibratior, microstructure, cutting |
| Abstract: | In the diamond turning which conjunction with fast tool servo (FTS), burr formation is a key factor of the work piece surfaces roughness and diamond tool wear. This paper presents a machining method that combined the ultrasonic vibrator with the FTS device, in order to improve the precision of the work piece surface. An ultra precision machine was used to move the FTS device in the cutting direction. The single crystal diamond tool was utilized to cut the work piece. This paper experimentally investigates the effect of cutting parameters on cutting performances in the machining of brass by applying both the conventional FTS and the combination FTS method. It is observed that the combination FTS method improves the cutting patterns and reduces the formation of the burr at low cutting speed as compared to the conventional FTS method. |
 | View PDF© of paper |
| Up | |
|
